What is the JET?
The JET is a revolutionary hand tool which supports masonry by horizontally pre stressing the brickwork above a proposed opening with a force great enough to prevent collapse and allow an unobstructed access to the job.
|
 |
| |
 |
How does it work?
When preparing to either replace or create an opening in the wall simply remove the mortar from bricks at the advised spacing’s, insert the JET’s and tighten them up. |
| |
What Happens then?
Once the JET’s are in place that’s it – You can start work! The cross pressure of around 3.28kn created by the JET far exceeds the recommended 2.1kn to prevent collapse!
Simply insert the JET’S, tighten them up, do your work, remove the JET’s, re mortar and the job is done!!
|
 |
| |
 |
Why the JET?
Simple!! The JET saves you money, labour time, space in the van and is the easiest to install solution on the market that can be transported in a tool kit!! |
| |
Where has the JET come from?
The JET was invented and developed by Mr. Andrew Lundie, an experienced and respected building contractor who has developed this product using years of firsthand knowledge. |
 |
| Anything else i need to know? |
| |
| Testing: |
The JET has been fully tested by CERAM Building Technology and is backed up
by a full test report.
|
| |
| Suitability: |
Suitable for openings in brickwork up to 2250mm without the use of any additional support devices. |
| |
| Unique Features: |
Easy to handle, reusable, very little storage space required, can be used off the ground floor, can be used to shore up unstable brickwork.
|
| |
PATENT PENDING
GB10172955
US2008229701
EP05708433
|
|
| |
